Need help?Do you have a question about the Kenwood TS-780 and is the answer not in the manual?
General| Brand | Kenwood |
|---|---|
| Model | TS-780 |
| Category | Transceiver |
| Language | English |
Details receiver front-end, mixers, filters, AGC, and FM demodulation.
Explains audio path, balanced modulator, frequency modulation, and transmitter IF signal.
Details CPU clock, ROM/RAM access, and program execution flow.
Diagram showing signal levels at various stages of the receiver circuit.
Diagram showing signal levels at various stages of the transmitter circuit.
Lists essential test equipment for calibration and maintenance procedures.
Provides initial setup steps and switch/knob settings before adjustments.
Details voltage checks, mode settings, and specific voltage measurements for calibration.
Covers BPF, sensitivity, and S meter adjustments for the 2m band.
Covers BPF, sensitivity, and S meter adjustments for the 70cm band.
Details setting, power output, protection, and RF meter adjustments for 2m.
Details setting, power output, and protection adjustments for 70cm.
Covers common adjustments like carrier suppression and ALC meter.
Procedure to adjust frequency deviation for FM transmission.
Steps to check and verify the VOX and Anti-VOX functions.
Lists general specifications like frequency range, modes, power, and dimensions.
Details transmitter specifications including power output, modulation, and frequency response.
Lists receiver specifications like sensitivity, IF frequencies, and selectivity.
To Next Page
