Need help?Do you have a question about the Kenwood TS-790A/E and is the answer not in the manual?
General| Brand | Kenwood |
|---|---|
| Model | TS-790A/E |
| Category | Transceiver |
| Language | English |
Explains circuit design by band, including IF signal routing.
Describes the analog signal path and receiver circuits.
Details circuit control for transmit and receive bands.
Explains the sidetone circuit for CW keying.
Lists components for the switch unit (X41-3050-00).
Lists components for the RF unit across different frequency bands.
Lists components for the 144MHz final unit (X45-3150-00).
Lists components for the IF unit (X48-3050-XX).
Provides electrical characteristics for ceramic filters.
Details pin assignments and block diagram for PLL ICs.
Lists max rating and electrical characteristics for power modules.
Explains the front panel ACC 3 jack's function and cautions.
Describes the ACC4 connector and its pin assignments.
Provides guidance on using the parts list and component symbols.
Lists specific components for the RF unit (X44-3070-00).
Lists components for the 144MHz PLL unit (X50-3080-00).
Provides diagrams and steps for disassembling the transceiver.
Shows disassembly steps for the UT-10 option.
Lists necessary test equipment for adjustments.
Details common adjustments for various settings.
Provides adjustment steps for the 144MHz PLL system.
Details adjustment procedures for the 430MHz PLL system.
Lists terminal functions for the switch unit (X41-3050-00).
Details terminal functions for the 144MHz RF unit (X44-3070-XX).
Describes terminal functions for the IF unit (X48-3050-XX).
To Next Page
