To Next PageTo Next Page
Need help?Do you have a question about the Kenwood TS-711E and is the answer not in the manual?
General| Power Supply | 13.8 V DC |
|---|---|
| Antenna Impedance | 50 ohms |
| Frequency Range | 144-146 MHz |
| Mode | FM |
| Selectivity | 12 kHz (-6 dB) |
| IF Rejection | 70 dB |
| Sensitivity | 0.25 μV (12 dB SINAD) |
Summarizes core features like DCS, compact design, stability, display, memory, modes, tuning, and microprocessor functions.
Details microprocessor-controlled functions (SCAN, SPLIT etc.) and PC interface.
Covers general specs (range, voltage) and transmitter specs (output, modulation, deviation).
Details receiver specs (sensitivity, selectivity) and DCS control parameters.
Explains POWER switch, S meter, frequency display, and CH.Q switch.
Details VFO step settings and CH.Q switch functionality for tuning modes.
Covers MIC, RF PWR, SQL, IF SHIFT controls, and RIT/CLEAR switches.
Explains RF GAIN control for sensitivity and AF control for audio output level.
Describes VOICE, NB, DOWN/UP, COM, VFO/M, and FUNCTION switches.
Details the STEP function for frequency steps and SPLIT function for split operation.
Explains A=B, M=V functions, and Main Dial control in different modes.
Covers MODE keys, AUTO, SCAN, M.IN, and REV & LOCK operations.
Details ALERT operation, DCS system features, and call sign entry.
Explains DCS coded squelch, 5-digit ASCII codes, and call sign entry procedures.
Covers ATT attenuator, ALC/RF, PROC, RPT, and OFFSET switches.
Details headphone and MIC connector specifications.
Explains indicator lights and rear panel connectors for antennas, ground, speakers, etc.
Explains auto mode setting, beep confirmations, dial frequency, and initial setup.
Guides through initial switch settings and receive operation for FM mode.
Details FM operation, including signal reception and tuning, and SSB reception.
Covers SSB transmission procedures and CW operation basics.
Explains CW operation, tuning, semi break-in, and satellite communication basics.
Details RIT, IF SHIFT for interference, and RF GAIN for receiver sensitivity.
Explains RF PWR control for output power and the auto reset thermal protector.
Covers memory channels, contents, and the process of memory entry.
Details program scan, memory scan, and mode scan operations.
Explains locking memory channels and ALERT operation for M1 monitoring.
Describes DCS system features and call sign entry methods.
Provides detailed steps for entering call signs using decimal ASCII codes.
Details digital code entry, storage, and the function of the standby indicator.
Explains digital code standby mode and DCS squelch operation.
Describes code scan functionality and DCS system operation.
Covers antenna requirements, SWR, and connection for fixed stations.
Details power supply options and external speaker connections.
Guides on transceiver mounting in a vehicle and antenna installation.
Covers mobile power supply connection and ignition noise suppression.
Explains adjusting beep volume, main dial torque, and monitoring call signs.
Details backup battery replacement, microprocessor resetting, and ACC1/ACC2 jack uses.
Provides solutions for common transmitter and receiver problems.
Lists optional accessories like external speakers, mobile mount kits, and microphones.
Details installation procedures for voice synthesizers and subtone units.
Explains frequency configuration and the RF unit's reception/transmission systems.
Details the IF unit's reception systems for SSB/CW and FM modes.
Describes IF unit reception, AF unit functions, and final/AVR unit descriptions.
Details the PLL unit and the basic configuration of the control unit.
Covers control unit operations, microprocessor functions, and DCS system control.
