Need help?Do you have a question about the Kenwood TS-711A/E and is the answer not in the manual?
Detailed steps for operating the transceiver in FM mode.
Instructions for operating the transceiver in Single Side Band mode.
Guidance on operating the transceiver in Continuous Wave mode, including tuning.
Details how to store, recall, and manage memory channels, including program scan.
Explains the Coded Squelch system, including digital code entry, standby, and squelch operation.
Recommendations for selecting and installing antennas and ensuring proper grounding.
Details the signal path from antenna input to the IF unit for SSB/CW and FM modes.
Describes the signal path from the AF unit to the final RF output for SSB/CW and FM modes.
Detailed steps for operating the transceiver in FM mode.
Instructions for operating the transceiver in Single Side Band mode.
Guidance on operating the transceiver in Continuous Wave mode, including tuning.
Details how to store, recall, and manage memory channels, including program scan.
Explains the Coded Squelch system, including digital code entry, standby, and squelch operation.
Recommendations for selecting and installing antennas and ensuring proper grounding.
Details the signal path from antenna input to the IF unit for SSB/CW and FM modes.
Describes the signal path from the AF unit to the final RF output for SSB/CW and FM modes.
General| Mode | FM |
|---|---|
| RF Power Output | 10 W |
| Image Rejection | 70 dB |
| IF Rejection | 70 dB |
| Spurious Response Rejection | 70 dB |
| Supply Voltage | 13.8 VDC ±15% |
| Antenna Connector | SO-239 |
| Selectivity | 15 kHz at -6 dB |
| Audio Output | 2 W into 8 Ohms |
| Current Drain (Receive) | 0.8 A (squelched) |
To Next Page
