Need help?Do you have a question about the Kenwood TS-700A and is the answer not in the manual?
Block diagram illustrating the GEN UNIT.
Block diagram illustrating the AF UNIT.
Block diagram illustrating the FM IF UNIT.
Block diagram illustrating the CAR UNIT.
Block diagram of the MARKER UNIT.
Block diagram of the B.P.F. UNIT.
Block diagram of the MIX UNIT.
Block diagram of the FINAL UNIT.
Block diagram of the VFO UNIT.
Block diagram of the POWER SUPPLY UNIT.
Block diagram of the CARRIER UNIT.
Procedure to adjust the power supply unit voltages.
Procedure to adjust the CARRIER unit.
Procedure to adjust the VFO unit.
Procedure to adjust the HET unit for both models.
Procedures for adjusting fixed channels and output level.
Procedures for adjusting the receiver section.
Procedures for adjusting the transmitting section.
Procedures to adjust MIX and FINAL units.
Procedures for ALC, RF meter, and FM transmission adjustments.
Procedures for tone, CW/AM, carrier, and BPF unit adjustments.
Block diagram illustrating the GEN UNIT.
Block diagram illustrating the AF UNIT.
Block diagram illustrating the FM IF UNIT.
Block diagram illustrating the CAR UNIT.
Block diagram of the MARKER UNIT.
Block diagram of the B.P.F. UNIT.
Block diagram of the MIX UNIT.
Block diagram of the FINAL UNIT.
Block diagram of the VFO UNIT.
Block diagram of the POWER SUPPLY UNIT.
Block diagram of the CARRIER UNIT.
Procedure to adjust the power supply unit voltages.
Procedure to adjust the CARRIER unit.
Procedure to adjust the VFO unit.
Procedure to adjust the HET unit for both models.
Procedures for adjusting fixed channels and output level.
Procedures for adjusting the receiver section.
Procedures for adjusting the transmitting section.
Procedures to adjust MIX and FINAL units.
Procedures for ALC, RF meter, and FM transmission adjustments.
Procedures for tone, CW/AM, carrier, and BPF unit adjustments.
General| Brand | Kenwood |
|---|---|
| Model | TS-700A |
| Category | Transceiver |
| Language | English |
To Next Page
