To Next PageTo Next Page
Need help?Do you have a question about the Kenwood X600F and is the answer not in the manual?
General| Number of Channels | 4 |
|---|---|
| Signal-to-Noise Ratio | 95dB |
| Low Pass Filter | 50Hz - 200Hz |
| High Pass Filter | 50Hz - 200Hz |
| RMS Power at 4 Ohms | 60W x 4 |
| Frequency Response | 5Hz - 50kHz |
| Input Sensitivity | 200mV - 5V |
| Crossover | HPF/LPF selectable |
Manual for the Kenwood X600F four-channel power amplifier.
Instructions for recording serial numbers for warranty and service purposes.
Information on registering the Kenwood product online for support and updates.
Critical safety instructions to prevent injury, fire, and damage during installation and use.
Precautions to prevent damage to the amplifier, including power supply and environmental considerations.
FCC warning and note regarding radio frequency energy and interference compliance.
Guidelines for cleaning the unit and preventing battery drain.
Explanation of protection functions and essential wiring guidelines for safe operation.
Advice on selecting compatible speakers based on impedance and power ratings.
List of accessories provided with the amplifier for installation.
Detailed, step-by-step instructions for properly installing the amplifier.
Important cautions regarding unsuitable installation locations to ensure safety and performance.
Visual guide and instructions for connecting power, ground, RCA, and speaker wires.
Instructions for preparing and installing wires into the amplifier's terminals.
Explanation of how to configure bridged connections for higher power output.
Diagram showing a typical 4-channel speaker setup.
Diagram illustrating a 2-channel bridged configuration for maximum power.
Diagrams for connecting two main speakers and a subwoofer.
Description of power, ground, and speaker output connection terminals.
Explanation of line input/output jacks and status indicator lights.
Details on adjusting input sensitivity, crossover frequencies, and bass boost levels.
How to use switches for input selection, stereo/mono modes, and filtering.
Guide to identifying and resolving common operational problems with the amplifier.
Detailed specifications including power output, frequency response, impedance, and physical size.
