Kera SELENA - Wake-Up Alarm Clock Setup

SELENA Multifunctional LED Clock USER MANUAL V32D
KERA TECHNOLOGIES INC. 2013 www.ledclocks.com
15
HALTING the ALTERNATING DISPLAY in the TEXT section
User may (ON DEMAND) HALT the alternating display by pressing the FUN key at any time. The screen currently on the text
display will remain active until the TALK key is pressed.
To scroll quickly through the enabled text screens, press the TALK key repeatedly.
IMPORTANT ! Some TEXT modes may NOT be available in some clock models.
ZONE TEXT Setup
SELENA clocks equipped with the alphanumeric TEXT display option can display any custom programmed text, for instance
the time ZONE name. The text is stored in a permanent memory and will remain there until changed, even without power.
To Enable the ZONE TEXT PRESET mode, enable the function Fn 86. The function Fn 85 must also be enabled.
NOTE that the clock programming mode DOES NOT HAVE TO BE ACTIVATED to program the ZONE TEXT.
1. Press the SET key to initiate the ZONE TEXT Preset Mode.
The left-most character in the Text display section will begin to flash.
NOTE, that if the character has been previously set as “ “ ( space) it may not show as flashing. Continue to the next
step.
2. Press the UP or DN key to preset the character.
Use the NXT key to move the flashing cursor to the next position.
3. When finished programming of all characters, press the MUTE key to store the entire text in the internal memory.
4. To DISABLE the text preset mode, disable the function Fn 86.
When this function is disabled, the SET key will not activate the text preset mode, and may be used normally for all
other timer/counter modes.
5. If the TEXT / DATE alternating mode was set as active, remember to press the TALK key after the programming of
the text is finished in order to resume the alternating mode.
WAKE -UP ALARM CLOCK Setup
SELENA can be set to function as an Alarm Clock and perform programmable Wake-up Alarm for each day until disabled.
To enable the WAKE-UP ALARM mode, make sure that the functions Fn 39, 31 and all other Timer/Counter and Thermostat
modes are DISABLED.
In this mode only HOURS:MINUTES can be set and during this preset the display will always operate in the 24-hour format.
NOTE that the programming mode DOES NOT HAVE TO BE ACTIVATED to preset the Wake-Up Alarm, which may be
performed at any time during the normal clock operation (if Stopwatch or other programmable timers are Not Enabled).
1. Press the SET key to initiate the WAKE-UP ALARM Preset Mode.
2. Using the UP and DN keys preset the Alarm HOURS and MINUTES.
Use the NXT key to move from minutes to hours and back.
NOTE. To reset the time to 0:00 press the CLR key.
3. When finished, wait for several seconds without pressing any keys. The clock will resume normal operation and a
DOT in the lower-right corner of the display will begin to flash. This is an indication that the Alarm is preset and
active.
4. TO CANCEL the Wake-Up Alarm, press the STOP key at any time during the normal clock operation.
The lower-right decimal point will be switched off in response.
NOTE that the Wake-Up Alarm may be activated at any time during the normal clock operation by pressing the SET key.
If the preset Alarm Time is satisfactory, wait for few seconds for the display to return to the regular operation mode. Slow
flashing of the lower-right decimal point will indicate that the alarm is activated.
IMPORTANT.