Kerlink Wirnet iFemtoCell-evolution 923 - Page 9

V3.0 | 01.06.2020 | Page 8
7. Declaraon of Conformity
7.1 Wirnet™ iFemtoCell-evoluon 868
Simplied EU Declaraon of Conformity
Hereby, Kerlink, declares that the radio equipment type Wirnet™ iFemtoCell-evoluon 868 is in
compliance with Direcve 2014/53/EU.
The full text of the EU Declaraon of Conformity is available at the following internet address:
www.kerlink.com/support
In Europe, the Wirnet™ iFemtoCell-evoluon 868 staon must comply with the ERC 70-03
requirements regarding duty cycle and maximum EIRP. They are summarized in the following table
ERC 70-03 Frequency (MHz) Power Duty Cycle
h1.4 865-868 14dBm ERP 1%
h1.5 868-868,6 14dBm ERP 1%
h1.7 869,4-869,65 27dBm ERP 10%
The power supply of the Wirnet™ iFemtoCell-evoluon 868 must be a limited source of power. Note that:
If the LoRa antenna is changed, the output power must be adjusted to take into account the gain of the
antenna in order to not overrule the ERC 70-03 recommandaon.
Some countries in Europe may have specic frequency ranges, EIRP and duty cycles regulaons. Check the
local regulaons before installing and commissioning the Wirnet™ iFemtoCell-evoluon 868.
For other countries, outside Europe, check the frequency range, the maximum EIRP and duty cycle allowed.
password such as root/root, default password is built using the last 6 digits of the serial number, of
CPU module ID for Wirnet iBTS and « board ID » for Wirnet iFemtoCell, iFemtoCell-evoluon and
Wirnet iStaon: pdmk-$serialno.
For example, if the serial number of a CPU module is 641ATe0507DD, then the root password will
be pdmk-0507DD (case sensive).
This 6 digits number can also be retrieved in the hostname. It is displayed in the shell prompt:
klk-lpbs_0507DD login: root
Password: pdmk-0507DD
For security reasons, it is strongly recommended to change the default passwords.
More informaon on the Kerlink Wiki: www.wikikerlink.fr in the secon “Connect to the gateway”
and in the secon “Setup”.