32 TALJG_A/TALSG_A/TPLJG_A/TPLSG_A-BA-e-2011
Leveling
Accurate setting and stable installation are the conditions enabling to obtain
repeatable results. Small unevenness or inclination of the base surface can be
compensated by leveling the scale.
•
Level the scale using the leveling feet. The air bubble in
the leveler must be present in the marked area.
• Check leveling at regular intervals.
Connecting power supply
Connect the scale power supply.
The scale autotest will be carried out. Next, the scale will switch to the
stand-by mode.
The scale connected to the power supply is always on. When you press
the ON/OFF button, the display will be switched on or off.
To Next Page
Loading...
