PARADIGM – INSTALLATION/OPERATION MANUAL
Paradigm
4 Jun 10
1.6 SHUTTING FURNACE DOWN
In case of emergency it is important to know where the emergency power isolation switch is
located.
POWER OFF Turn off main power switch.
FUEL OFF Shut off manual fuel supply valve.
It is important to contact a service technician before shutting the furnace down for an extended
period of time.
Always keep manual fuel supply valve shut off if the burner is shut down for an extended
period of time.
1.7 RESTARTING FURNACE
Follow this procedure before restarting a unit that has been shut down for an extended period
of time.
INSPECTION Have the furnace/system serviced and inspected by a qualified technician.
Ensure that the furnace/system has not been tampered with.
FUEL Turn on fuel supply and check that there are no leaks.
POWER Turn on power switch and check that the furnace starts and operates as usual.
OPERATION If the furnace/system fails to operate or operates in an unusual manner, call
your service technician. If the burner fails to operate at any time, call a qualified
burner technician.
DO NOT ATTEMPT TO START BURNER WHEN EXCESS OIL HAS ACCUMULATED, WHEN
UNIT IS FULL OF VAPOUR, OR WHEN HEAT EXCHANGER IS VERY HOT.
2.0 INSTALLATION
2.1 IMPORTANT
Read this installation manual thoroughly before installing furnace or starting burner. Consult
local authorities about your local Fire Safety Regulations. All installations must be in
accordance with local state or provincial codes. Improper installation will result in voiding of
warranty.
2.2 CAUTION
DO NOT:
o Start the burner until all fittings, covers and doors are in place.
o Tamper with the furnace or controls – call a qualified burner technician.
o Store or use gasoline or other flammable vapours and liquids in the vicinity of this or any
other appliance.
o Start the burner unless the blower access door is secured in place.
To Next Page
Loading...