Kesla 2014 - Turning Device Maintenance

MAINTENANCE
50
8.5 TURNING DEVICE
8.5.1 Lubrication of the turning device
- For lubrication a couple of squeezes with a grease gun is enough.
* The top bearing of the turning device (2 grease nipples) should be lubricated regularly.
* The turning device is in other respects oil flooded. Check the oil level on the level surface through
the oil eye. If necessary, add (hypoid oil SAE 80W/90).
Täyttöaukko = Filling hole
Öljysilmä = Oil gauge
Tyhjennys = Draining
* The top pivot of the stabilizer has 2 grease nipples and in the front bar (in the swing) 1 grease
nipple.