Kestrel 5000 User Manual

20
Press only the sides of the impeller when removing and inserting
to avoid damaging the precision hub bearing. [
Figure 1] .
» Press FIRMLY on the impeller module to remove it.
» Insert the new impeller so the side that has the
small triangle (close to the perimeter) faces the
front of the Kestrel when installed.
Figure 1
IMPELLER REPLACEMENT
» Orient one “arm” of the module straight up .
[
Figure 2]. The impeller can be pushed in from
either side.
Figure 2

Kestrel 5000 Specifications

General

Wind Speed Accuracy	±3% of reading
Humidity Accuracy	±3% RH
Pressure Resolution	0.1 hPa
Water Resistance	IP67
Measurement Parameters	Wind speed, Temperature, Humidity, Pressure, Altitude
Temperature Range	-29 to 70°C (-20 to 158°F)
Temperature Accuracy	±1 °C
Humidity Range	0 to 100% RH
Pressure Range	750 to 1100 hPa
Pressure Accuracy	±1.5 hPa
Altimeter Range	-2000 to 9000 m
Display	High-resolution, sunlight-readable, monochrome LCD
Data Logging	Yes
Battery Life	Approximately 400 hours
Operating Temperature	-10 to 55 °C