KETRON SolTon PROGRAMMER 24S - Page 9

pies атынан See te RSS. cus Edgard, St ыы лын»
and Piano (ог Synt). (Piano and Synt voices can А play together). Up to 1200r notes available for
each track. These 2 sequencer lines can be memorized on each of the 64 Patterns following the
normal Pattern functions. Bass and Piano programs may be programmed in Real Time or Step
by Step.
2) SONG SEQUENCER: 1 track polyphonic sequencer (7 notes) for Chord programming or har-
monizing.
The Song-Chords Sequencer programming can be made through the Song functions in Real Ti-
me, upon an existing Rhythm chain.
All informations regarding the Chord Sequencer are examined on the chapter Song-Chord Se-
quencer in the Раде n. ...
PATTERN SEQUENCER
BASS and PIANO REAL TIME PROGRAMMING
For Real Time Programming of the Bass and Piano Sequences, carry out the following steps:
1) Press PATTERN and select the Pattern number required.
2) Press several times PATTERN until obtaining RECORD.
3) Press START. The Metronome starts beating (or Rhythm, if it has been programmed).
4) On the Sequencer Section the controls BASS or PIANO (SYNT) have to be inserted, according
to the sequence you wish to program.
5) Insert RECORD on the Sequencer section (if RECORD does not light ир, make sure that Ma-
nual Drums and MEMORY is not inserted).
6) Play the required BASS or PIANO (SYNT) notes on the keyboard or in the Pedalboard. (In case
of Bass programming one of the four Bass effects have to be inserted; in case of piano pro-
gramming piano must be on).
The pressed notes will be immediately replayed by the Sequencer in the same way as they have
been recorded.
IMPORTANT: If Record, Bass and If Record, Bass and Piano are on, Piano (or Synt) sequence
can be played hearing the bass line already programmed.
7) SEQUENCE CLEAR. This function permits to cancel eventually existing errors in the Bass or in
the Piano Sequence.
To make any Clear operation follow this procedure:
A) Make sure that Pattern and Sequencer are in RECORD position
B) Press Bass or Piano or both (according if you want to Clear the Bass, the Piano or both)
C) Press Start
D) Press Clear. Clear has to be left inserted in the Sequencer section during the complete Pattern
length.
Then switch off Clear and repeat the Sequence programming.
NOTES
1) If the Sequence is programmed with Metronome only, the first note played will be accepted as
first beat of the Pattern.
2) If the Sequencer is programmed together with an existing Rhythm Pattern or with a Preset the
length of the sequence will be the same as the length of the guiding Preset Pattern.
3) The programmed sequence may sound with the Arranger, but in this case the Bass and the Solo
lines of the Arranger will be replaced by the Sequencer lines.
4) Sequencer programming can be made on all 37 keys and in any key.
However, if you want the sequences to follow the chords you play on the Programmer 24S IT
IS NECESSARY to program the sequences in C tonality (Key of C major).
BASS AND PIANO STEP BY STEP PROGRAMMING
This system is particularly suitable for programming more elaborate sequences, or at any rate se-
quences that cannot be carried out on the keyboard in real time.
The phases of note by note programming are similar to the ones already described in the Rhythm
Chapter:
1) Insert PATTERN (adjust Time and Error Correct values as desired)
2) Press PATTERN three times (STEP MODE lights up).
3) Press START. On the Display 001 appears. If a different number appears, first press STOP
CONTINUE and then START until obtaining 001 on the Display.
==