EasyManua.ls Logo

Kettler E3 - Safety Information; Your Safety; Safety Instructions

Kettler E3
96 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Training and Operating Instructions
2
GB
Safety Instructions
Note the following points for your own safety:
The training apparatus must be set up on a suitable,
stable surface.
Before the first use and also after approx. 6 operating
days, the joints are to be checked for firmness.
In order to avoid injuries as a result of incorrect loa-
ding or excessive loading, the training apparatus must
only be used in accordance with the instructions.
It is not recommended that the apparatus be set up in
damp spaces, because this will in time lead to rusting.
At regular intervals, check that the training apparatus
is in correct working order and that it is in proper con-
dition.
The safety / technical checks are among the duties of
the operator and must be carried out regularly and
properly.
Defective and damaged parts are to be replaced
immediately.
Only use original KETTLER replacement parts.
The apparatus must not be used until it has been repai-
red.
The safety level of the apparatus can only be maintai-
ned if it is regularly checked for damage and wear.
For your safety:
Before taking up training, have your family doctor
advise you on whether or not you are in suitable
health for training with this apparatus. The medical fin-
dings should be the basis for the structuring of your
training programme. Incorrect or excessive training can
lead to damage to health.
Table of contents
Safety Information
• Service 2
• Your safety 2
Function 3
• Display / Keys 3
Quick Guide 4
• Keys 4
• Programmes 5
• Displays 6
Quick Start (Introduction) 7
• Start of training 7
• Training break / ending the session 7
• Standby operation 7
Required inputs 8
• User data and settings 8
Date of birth, kJoules or kcal display,
real or physical energy expenditure,
alarm sound when maximum heart
rate is reached yes/no,
• System settings 9
Date, time, KM or miles, user selection,
factory settings
• Firmware update 9
Training 10
• User selection 10
• Training selection 10
By power targets 10
By heart rate targets 10
... By power targets 10
• "Up" programme 10
• "Down" programme 10
Target range 10
Training record yes/no 10
Time 10
Energy 10
Distance 11
Maximum heart rate 11
Target heart rate selection (fat/fit/man.)11
• Target heart rate input 11
• Ready for training 11
• Power profile HILL 11
... By heart rate targets 12
• HRC Up 12
• HRC Down 12
Training functions 13
• (Not) dependent on speed 13
• Training break / ending the session 13
• Restarting training 13
• Recovery (recovery heart rate measure-
ment) 13
Heart rate events display 13
• Table: Heart rate events 13
General Information 14
• System sounds 14
• Recovery 14
• Operation not dependent on speed 14
• Up / down arrows 14
• Operation dependent on speed 14
• Average value calculation 14
• Information on heart rate measurement14
With ear-clip 14
With hand grip 14
With chest strap 14
• Computer errors 14
• Interface information 14
Training instructions 14
• Endurance training 14
• Exercise intensity 15
• Scope of exercise 15
Glossary 15
In the instruction, this sign refers to
the glossary. There the respective
term is explained.
G

Table of Contents

Other manuals for Kettler E3

Related product manuals