8
Care and maintenance
Maintenance of the belt and the running board:
ATTENTION: The lubrication and care of the belt is the most important main-
tenance measure! An insufficient lubrication and the associated clear increa-
se of friction leads to more wear and tear and to damage of the treadmill belt,
running board, motor and circuit board!
Damages which occur from defective or neglected care and main-
tenance of the belt are not covered by the guarantee!
In case of a regular use of the running belt, the cold running belt has to be
serviced every 100 operating hours or every 2 month or when the service-
LED is displayed (also see computer manual) with silicone oil, article number
43008001.
Prior to the 1st commissioning of the device or after a longer period of not
using the device, this service has to be performed as well.
Insert the small spray pipe between the belt and the running
board and give 3 short (about 1 second) spray bursts of silicone
lubricant between the belt and the running board. The spray pipe
should be moved to one side to ensure that the entire lower side
of the belt is moistened. Then further turn the belt over by hand
so that the entire surface between the belt and the running board
is lubricated.
Wipe away any superfluous lubricant.
To Next Page
Loading...
Need help?
General