2. Cleaning the Funnel —The Funnel can be
removed from the K-Cup Holder by pulling
on it until it pops off (fig. 9). The Funnel is
dishwasher safe. To replace it, just snap it
back onto the K-Cup Holder Assembly.
3. Cleaning the Exit Needle —The Exit Needle is
located on the inside bottom of the K-Cup
Holder Assembly. Should a clog arise due to
coffee grinds, it can be cleaned using a paper
clip or similar tool. Remove K-Cup Holder
assembly and detach Funnel. Insert the paper
clip (as shown in fig. 9) into the Needle to
loosen the clog and push it out. The K-Cup
Holder is dishwasher safe.
CAUTION: There are sharp needles that puncture
the K-Cup above the K-Cup Holder and in the
bottom of the K-Cup Holder. To avoid risk of injury,
do not put your fingers in the K-Cup Assembly
Housing.
Cleaning the Water Reservoir & Water Reservoir Lid
The Water Reservoir Lid should be cleaned with a damp soapy non-abrasive
cloth. Lid should not be put into the dishwasher. The Water Reservoir can
be placed into the top shelf of the dishwasher (use low temperature cycles)
for cleaning or can be cleaned with soapy water and rinsed thoroughly. Do
not dry the inside of the Water Reservoir with a cloth as lint may remain.
CAUTION: Please rinse the Water Reservoir thoroughly after cleaning to
ensure that no cleaners or cleaning solutions remain in this area as they may
contaminate the water supply in the Brewer.
De-Scaling Your Brewer
Mineral content in water varies from place to
place. Depending on the mineral content of the
water in your area, calcium deposits or scale
may build up in your Brewer. Scale is non-toxic,
but left unattended, it can hinder Brewer
performance. De-scaling your Brewer helps
maintain the heating element, and other
internal parts of the Brewer that come in
contact with water.
The Brewer should be de-scaled every 3-6
months to ensure optimal performance. It is
possible for calcium deposits to build up faster,
making it necessary to de-scale more often.
This Brewer is equipped with sensors to
detect when scale buildup is interfering with
the performance of the Brewer. When this is detected, the red light next
to ‘DE-SCALE’ will be illuminated. (fig. 10) However, even if the red light next
to ‘DE-SCALE’ is not illuminated you should continue to de-scale your
Brewer every 3 to 6 months.
You should promptly de-scale if ‘DE-SCALE’ is displayed on the LCD Control
Center. Properly follow the de-scaling procedure described.
NOTE: The Brewer will continue to function even when ‘DE-SCALE’ is displayed.
However, if you do not de-scale soon after it is displayed, continued scale build-
up could damage the Brewer. If this occurs, ‘DE-SCALE’ will begin to blink to alert
you to the potential damage to the Brewer if you do not de-scale immediately.
To Next Page
Loading...
