Keurig K Brew+Chill - Page 3

CHILL
TANK
LIGHT
ADD WATER
STRONG
RINSE
COLD
HOT
CHILL TANK
DESCALE
QUIET
6oz 12oz
10oz8oz
ADD WATER
STRONG
RINSE
COLD
HOT
CHILL TANK
DESCALE
QUIET
6oz 12oz
10oz8oz
BREW
BUTTON
3. BREW
BUTTON
3. BREW
BUTTON
1. RINSE 1. RINSE
2. HOT 2. COLD
ADD WATER
STRONG
RINSE
COLD
HOT
CHILL TANK
DESCALE
QUIET
6oz 12oz
10oz8oz
ADD WATER
STRONG
RINSE
COLD
HOT
CHILL TANK
DESCALE
QUIET
6oz 12oz
10oz8oz
Fill the Chill Tank
The Chill Tank is the cooling engine of the K-Brew+Chill™. Any K-Cup® pod is brewed hot and then cooled using
QuickChill Technology™, resulting in a freshly brewed beverage as cold as one from a coffee shop. Before you get
started, make sure to fill the Chill Tank.
Remove and discard any
packaging materials and stickers.
Place your K-Brew+Chill
TM
where
you intend to use it before filling
it with water.
1
Plug the coffee maker in.
Remove the Chill Tank lid and
locate the opening with the
Max Fill tab.
2
CHILL TANK TIPS:
• The colder the water put into the Chill Tank, the quicker the unit can reach its coldest temperature.
• Fill the water reservoir 1.5 times or use a pitcher. Using a pitcher with a spout can make the filling experience easier.
• Position the K-Brew+Chill™ at least 6 inches away from obstructions for best cooling performance.
• Move the K-Brew+Chill™ away from other heating sources like stovetops.
• Do not place in direct sunlight.
3
Fill the Chill Tank with cool tap water.
NOTE: The colder the water, the faster the Chill Tank will charge.
The Chill Tank requires 11.5 cups of water. Pour slowly
until you reach the Max Fill tab and the CHILL TANK
light is no longer illuminated.
NOTE: The Chill Tank fan will turn on once you have filled with
enough water.
Reinstall the lid and press down firmly.
Before You Brew
Brew Your First Cup: Hot Coffee
Place a mug on the drip tray.
Lift the handle and insert a
K-Cup® pod, then close the
handle.
1
Fill the water reservoir to the
max fill line. If you have a Keurig®
Water Filter, install it now.
Place a 12oz mug on the drip tray.
NOTE: Do not use distilled water.
1
Lift and lower the handle. Do not
insert a K-Cup® pod. Press the RINSE button,
select HOT, and press the blinking K button to
begin the cycle. The cycle is complete when the
K button is no longer illuminated. Empty the
mug and place it back on the drip tray.
2
The K-Brew+Chill™ defaults to HOT. Choose
your brew size and press the K button to
start the brew. The brew is complete when
the K button is no longer illuminated.
2
TIP: Select STRONG before
starting the brew for a stronger
cup of coee.
TIP: To brew hot water, simply
follow steps 1 and 2 for brewing hot
coee and omit the K-Cup® pod.
Repeat these steps, but
select COLD to perform
a rinse cycle for the COLD
system.
3