RINSE
BUTTON
BREW
BUTTON
ADD WATER
STRONG
RINSE
COLD
HOT
CHILL TANK
DESCALE
QUIET
6oz 12oz
10oz8oz
ADD WATER
STRONG
RINSE
COLD
HOT
CHILL TANK
DESCALE
QUIET
6oz 12oz
10oz8oz
MULTISTREAM TECHNOLOGY™: Saturates the
grounds evenly to extract full flavor and aroma in every
cup, hot and cold.
QUICKCHILL TECHNOLOGY™: Cools the coffee down
to a refreshing temperature for chilled iced coffee in
less than 3 minutes.
COLD CHARGING BAR: Conveys the status of your Chill
Tank — low, medium, high, or fully charged — so you know
when your brewer is ready to brew its coldest beverage.
BREWS HOT AND COLD: Deliciously hot and
refreshingly chilled iced coffee.
QUIET MODE AND PAUSE: Allows you to control
the chilling speed of your brewer between High
Performance, Quiet, and Off modes. Press and hold
QUIET to sleep all cooling capabilities for 6 hours.
STRONG BREW: For a bolder, more intense cup.
RINSE: A manual cleaning cycle designed to ensure your
beverages taste great.
POWER OFF: To power your brewer on, simply press
any button or lift the brewer handle. Your brewer will
automatically turn off after 5 minutes. You can also
press and hold the HOT or COLD button to turn the
brewer off.
HIGH ALTITUDE MODE: To ensure your brewer works
properly at higher altitudes (5,000 feet), please enable
the High Altitude Brewing Mode on your brewer.
1. Begin with the brewer plugged in and powered off.
2. Press and hold the K button and 8oz button for 3
seconds. The Cold Charging Bar lights will flash twice
to confirm that the High Altitude Mode has been
enabled.
High Altitude Mode will remain enabled until steps 1-2
are repeated and the Cold Charging Bar lights flash
twice to confirm that the High Altitude Brewing Mode
is disabled.
Rinse Experience
WHEN TO USE RINSE FEATURE
• The Rinse feature is a manual cleaning cycle designed to ensure your beverages taste great, even after brewing
different pod varieties and flavors.
• Conduct a Rinse after each brew if your household brews any of the following beverage types.
• Flavored Coffee
• Tea
• Cocoa
• Refreshers
• One-Step Latte
Place a 12oz mug on the drip
tray. Open and close the
brewer handle. Do not insert
a K-Cup® Pod.
1
Press the RINSE button, then
select HOT or COLD. The 12oz
size will illuminate.
2
Press the K button to begin the
Rinse cycle. The cycle is complete
when the K button is no longer
illuminated.
3
Rinse Cycle
Brewer Features
QUIET
To Next Page
Loading...
