Make Your First Latte
Cleansing Brew
The cup sizes will blink. Press the
8 oz button to start a cleansing brew.
Pour the hot water into the sink.
Do not remove the water reservoir or
lift the handle once the brew button
has been pressed until the brew has
completed.
The one-time setup process is now
complete, and you are ready to brew!
Clean the Frother
Remove the lid and whisk from
inside the frother. Wash the interior
of the frother, lid, and whisk with
warm, soapy water. Dry all parts
thoroughly using a soft, nonabrasive
cloth, then reassemble.
NOTE: Frother is not dishwasher safe. Do not
submerge frother in water. Only use nonabrasive
cleaning materials to prevent damage to the
inner surface of the frother. Dry interior of
frother and base with a soft cloth after cleaning.
5
Lift & Lower
Lift and lower the handle.
Do not insert a K-Cup® pod.
The brewer will power on
automatically.
12
OZ
10
8
SHOT
STRONG
ADD WATER
DESCALE
12
OZ
10
8
SHOT
STRONG
ADD WATER
DESCALE
12
OZ
10
8
SHOT
STRONG
ADD WATER
DESCALE
1. Froth Milk
Remove lid and add milk to the
MAX line marked in the frother
(for cappuccino, fill to MIN line).
Replace the lid and place the
frother on the frother base.
Press the power button on
the frother.
The button will illuminate while
heating – up to three minutes.
Frothing is complete when the
button flashes and then turns off.
CAUTION: Frother is not microwave or
dishwasher safe.
NOTE: Do not under- or overfill frother.
Do not operate before adding milk.
2. Queue Your Brew
While frothing, lift the handle of your
brewer and place a K-Cup® pod in the
K-Cup® pod holder. Lower the handle
completely to close the lid, then place
a mug on the drip tray. The brew
selections will blink. Press the SHOT*
button. When frothing is completed,
the shot will automatically brew next.
NOTE: The brewer cannot brew coffee and
froth milk at the same time.
CAUTION: While brewing, there is extremely
hot water in the K-Cup® pod holder. To avoid
injury, do not lift the handle during the brew
process.
Do not remove the foil lid on the
K-Cup® pod before brewing.
*Can also queue any cup size, but SHOT is
recommended for coffeehouse beverages.
3. Create Your Latte
When shot is complete, remove
K-Cup® pod and recycle (see
instructions above).
Remove the frother from the base.
Remove the lid and pour the frothed
milk over your shot of coffee.
N
OTE: Clean frother immediately after
use. For cleaning instructions, see Caring
For Your Brewer section in this guide.
MAX
MIN
12
OZ
10
8
SHOT
STRONG
ADD WATER
DESCALE
12
OZ
10
8
SHOT
STRONG
ADD WATER
DESCALE
MAX
MIN
12
OZ
10
8
SHOT
STRONG
ADD WATER
DESCALE
Why Queue Your Brew
Since the brewer and frother cannot run
at the same time, queueing your brew
allows you to set up frothing and coffee
brewing so they automatically run back-
to-back.
To Next Page
Loading...
