Caring For Your Brewer
Brewer Features
Regular cleaning keeps your brewer running smoothly. Always be sure to turn off and unplug your brewer before cleaning.
Brewer Exterior
Keep your Keurig® brewer looking its best
by cleaning the exterior from time to time.
Just clean with a damp, soapy, lint-free,
nonabrasive cloth. Never immerse the
brewer in water or other liquids.
Drip Tray
The drip tray overflow should be emptied
and cleaned occasionally. To remove, lift
up off brewer base, keeping it level to avoid
spilling. Rinse and clean with a damp, soapy,
lint-free, nonabrasive cloth. Hand-wash only.
Water Reservoir
The water reservoir should be cleaned
periodically by wiping the inside of the
reservoir and underside of the lid with a
damp, nonabrasive, lint-free cloth. Do not dry
the inside of the water reservoir with
a cloth, as lint may remain. Allow the
reservoir to dry completely. Hand-wash only.
K-Cup® Pod Holder
Cap: For your Frother
Clean immediately after each use and
before first use.
To Clean:
1. Remove frother from the base, remove
silicone ring from lid, and remove the whisk
from inside the frother.
2. Wash the silicone ring, lid, and whisk with
warm, soapy water.
3. Clean the interior of the frother with soap
and rinse with warm water. Use a soft,
nonabrasive cloth or sponge to prevent
damaging the inner coating.
4. Wipe the exterior with a soft, damp cloth.
5. Dry all parts thoroughly and reassemble
for next use.
Note: Frother is not dishwasher safe. Do not submerge frother
in water. Only use nonabrasive cleaning materials to prevent
damage to the inner surface of the frother.
12
OZ
10
8
SHOT
STRONG
ADD WATER
DESCALE
12
OZ
10
8
SHOT
STRONG
ADD WATER
DESCALE
12
OZ
10
8
SHOT
STRONG
ADD WATER
DESCALE
12
OZ
10
8
SHOT
STRONG
ADD WATER
DESCALE
STRONG BREW: For a bolder, more intense cup. Select
STRONG before or after your cup size is selected. Cannot
be used with SHOT button.
FAST & FRESH-BREWED: Coffee made in minutes.
BACK-TO-BACK BREWING: Immediately brew a second
cup; no need to wait for reheating.
TRAVEL MUG FRIENDLY: Accommodates travel mugs up
to 7.25” tall.
SIMPLE BUTTON CONTROLS: Just insert any K-Cup® pod
and use the button controls to brew a delicious cup.
MAINTENANCE ALERT: Reminds you to descale after
every 250 brews. To DISABLE DESCALE notifications:
Power off the brewer and press and hold the 10 oz and
12 oz buttons for three seconds. STRONG will
illuminate to confirm alerts have been disabled. To turn
maintenance alerts back on, repeat the same steps;
SHOT will illuminate to confirm that alerts are enabled.
NOTE: Regular descaling enhances the taste of your coffee
and
the long-term performance of your brewer; it is highly
recommended
to continue this practice even if alerts are
turned off.
COMPATIBLE WITH THE MY K-CUP® UNIVERSAL
REUSABLE COFFEE FILTER: Brew your own ground
coffee (sold separately).
AUTO OFF: Automatically turns your brewer off five
minutes after the last brew for energy savings, but will
be ready to brew as soon as it is powered on again.
HIGH ALTITUDE: To ensure your coffee maker works
properly at higher altitudes (5,000 feet), please enable
the High Altitude Brewing Mode on your coffee maker.
1. Begin with the brewer plugged in and powered off.
2.
Press and hold the STRONG button and 10 oz button
for three seconds. The 12 oz button will illuminate to
confirm that the High Altitude Brewing Mode has been
enabled.
3. High Altitude Mode will remain enabled until steps
1-2 are repeated; the 12 oz light will turn off and the
8 oz light will turn on to confirm that the High Altitude
Brewing mode is disabled.
HIGH ALTITUDE BREWING: While holding the brewer
handle up, push down slowly on the K-Cup® pod in
the pod holder until the bottom of the K-Cup® pod is
punctured by the exit needle.
To Next Page
Loading...
