Coffee Maker Exterior
Keep your Keurig® coffee maker
looking its best by cleaning the
exterior from time to time. Just clean
with a damp, soapy, lint-free, non-
abrasive cloth. Never immerse the
coffee maker in water or other liquids.
Drip Tray
The drip tray can hold up to 237 ml/
8 oz of overflow and should be
emptied and cleaned occasionally. To
remove, slide it toward you, keeping
it level to avoid spilling. Clean in
dishwasher (top rack only) or rinse
and clean with a damp, soapy, lint-
free, non-abrasive cloth.
Water Reservoir & Reservoir Lid
The water reservoir lid and water
reservoir should be cleaned
periodically. Clean in a dishwasher
(top rack only) or hand wash. To
hand wash, use a damp, soapy, non-
abrasive cloth. Rinse the reservoir
thoroughly after cleaning. This will
ensure that no cleaning solutions
remain in the area as they may
contaminate the water supply. After
rinsing, fill the reservoir with clean water and return it to the
coffee maker. Do not dry the inside of the water reservoir
with a cloth as lint may remain. If needed, repeat above
procedures.
NOTE: If you are using a water filter inside the water reservoir, remove it before cleaning.
Caring for your Coffee Maker
K-Cup® Pod Holder
To remove the K-Cup® pod holder
from the coffee maker, lift the handle
and grasp the top of the K-Cup® pod
holder with one hand while pushing
up on the bottom of the K-Cup® pod
holder from underneath with the
other until it releases. After cleaning,
align the K-Cup® pod holder with the
opening using the two front ribs
as a guide and snap into place from
the top.
CAUTION: There are sharp needles that puncture the K-Cup® pod above the K-Cup® pod holder and in the
bottom of the K-Cup® pod holder. To avoid risk of injury, do not put your fingers in the K-Cup® pod holder.
Funnel
The funnel can be removed from the
K-Cup® pod holder by pulling on it until
it pops off. To replace it, just snap it
back onto the K-Cup® pod holder.
Exit Needle
Remove the pod holder assembly and
detach the funnel. Locate the exit
needle on the inside bottom of the
K-Cup® pod holder. Insert a straightened
paper clip into the exit needle to loosen
the clog and push it out.
Entrance Needle
Lift the coffee maker handle and locate the entrance needle
on the underside of the lid. To clean both holes in the needle,
hold the coffee maker handle in the upward position and
with your other hand, carefully insert a straightened paper
clip into both holes. Gently move it around to loosen any
coffee grounds. Lower the handle completely and run two
water-only brew cycles. Do not insert a K-Cup® pod.
TIP: Refer to keurig.ca for video instructions on cleaning the entrance/exit needles.
Regular cleaning keeps your coffee maker running smoothly. Always be sure to turn off and unplug your coffee maker before cleaning.
Strong
Auto Off
AddWater
D
escale
S
t
r
on
g
M
A
X
.
Strong
Auto Off
Add Water
D
e
s
c
a
l
e
Strong
AutoOff
AddWater
D
e
s
ca
le
To Next Page
Loading...
Need help?
General
