Step 1
Remove all adhesive tape from Brewer and label
from Touchscreen. Behind the Brewer is a convenient
compartment to hold the Power Cord for storage.
Plug cord into grounded outlet.
If Brewer has been exposed to temperatures below freezing, allow
Brewer at least two hours to reach room temperature before
brewing. A frozen or extremely cold Brewer will not operate.
Step 2
Carefully remove Water Reservoir Lid. Remove the Water
Reservoir by lifting up and away from the Brewer.
Rinse Water Reservoir with fresh water. Return Water
Reservoir to Brewer. Fill the Water Reservoir to the max fill
line. Bottled or filtered water is recommended. Place Lid
on Water Reservoir.
See page 16 for options for how to add water to the
Water Reservoir.
Step 3
Place a 10 oz. mug toward the back of the Drip Tray and
press the Power Button.
The Brewer Handle should be in the lowered position.
Step 4
When the Brewer is first turned on, the Touchscreen
will indicate “Preheating” as the Brewer heats the water.
Wait until the Touchscreen indicates “Lift to Brew”
(about four minutes).
If there is not enough water in the Water Reservoir,
the Touchscreen will indicate “Please Add Water.”
Lift and lower the Brewer Handle, then press the flashing
“BREW” Button. Your Brewer will dispense 8 oz. of hot
water into your mug. Once complete, discard the hot
water. You are ready for your first brew!
SECTION 2
Preparing Your Brewer
Step 1
Step 2
Step 3
Step 4
8
KER484_UserGuide.indd 8 9/16/11 9:35 AM
To Next Page
Loading...
Need help?
General
