29
EN
Key Automation S.r.l. produces systems for the automation of gates,
garage doors, automatic doors, roller blinds and car-park and road
complete automation system, which is the outcome of the analysis,
assessment, choice of materials and installation work of your cho-
sen installer. Every automation system is unique, and only your
installer has the experience and skill required to produce a safe,
reliable, durable system tailored to your needs, and above all that
complies with the relevant regulatory standards. Although your au-
tomation system complies with the regulation safety level, this does
not rule out the presence of “residual risk”, meaning the possibility
that hazards may occur, usually due to reckless or even incorrect
use. We would therefore like to give you some advice for the correct
use of the system:
installer explain the potential causes of residual risks to you;
owner of the automation system;
dangerous: do not operate the automation system with people, ani-
since its sensor systems prevent it from moving with people or ob-
stacles present so that its operation is always predictable and safe.
-
se to the automation system, and to prevent involuntary activation,
remote controls must not be left within their reach;
electricity supply and perform the manual release procedure. Never
attempt repairs on your own; call in your installation engineer. In
the meantime the door or gate can be operated without automation
once the geared motor has been released using the release key
supplied with the system. In the event of safety devices out of ser-
vice arrange for repairs to the automation immediately;
engineer to come (or for the power to be restored if your system is
procedure must be carried out;
procedure can only be carried out with the door or gate stationery.
regular periodic maintenance to ensure its long life and total safe-
ty. Arrange a periodic maintenance schedule with your installation
engineer. Key Automation recommends that maintenance checks
should be carried out every six months for normal domestic use, but
this interval may vary depending on the level of use. Any inspection,
staff.
parameters: this is the responsibility of your installation engineer.
the person who performs them and the documents must be conser-
ved by the system’s owner.
-
mended to perform, are cleaning of the photocell glass and removal
of any leaves or stones that may obstruct the automation system.
-
tomation system before starting. Clean only with a cloth dipped in
a little water.
At the end of its useful life, the automation system must be disman-
disposed of in compliance with the legislation locally in force.
If after some time your remote control seems to have become less
-
pending on the level of use, this may take from several months up
to more than a year). You will realise this because the transmission
short time.
Batteries contain pollutants: do not dispose of them with normal wa-
-
net site www.keyautomation.it for further information.
To Next Page
Loading...
Need help?
General
