Key Automation CT20324 - 4.6 - Factory Parameters Reset; 5 - System Customisation; 5.1 - Basic Parameters

EN
14
5 - SYSTEM CUSTOMISATION
4.6 - Factory parameters reset
To return all the parameters to their default values or to change the type of equipment on which the control panel is installed, proceed
as follows:
1. Press and hold the button
(MENU); the display shows in sequence BASE ADV ; release the button near the text ADV.
2. Scroll through the menu items with the buttons
(UP) and (DOWN-RADIO) until reaching MOTOR SETUP
3. Press and hold the button
(MENU); release the button when the display starts ashing; the number displayed indicates the type
of motor in use.
4. Select with the buttons
(UP) and (DOWN-RADIO) the type of motor; press and hold the button (MENU).
The display shows a countdown from 50 to 0; release the button when the text DONE appears.
5. The control unit exits the MENU after seven seconds of inactivity or by briey pressing the
(MENU) button.
WARNING !
If the type of motor is changed, all the values are returned to the factory value and it is necessary to perform a new
auto-learning procedure for the travel.
The conguration menus of the equipment operating functions are divided into BASE and ADV (basic/advanced). The following tables
show the description of each basic parameter with the respective minimum, maximum and default values.
1. Press and hold the button
(MENU); the display shows in sequence BASE and ADV , release the button at the wording BASE to
access the basic menu.
2. Scroll through the menu items with the buttons
(UP) and (DOWN-RADIO) until reaching the desired parameter
3. Press and hold the button
(MENU) until the display ashes; release the button (MENU)
4. To change the value, use the buttons
(UP) and (DOWN-RADIO) ; to conrm the new value press and hold the button
(MENU) until the display stops ashing
5. To exit the menu, briey press the button
(MENU)
NOTE: to view the value of any parameter simply enter the relevant menu (BASE or ADV) using steps 1 and 2 of the procedure just
described. Once the desired parameter has been identied, the display alternately shows the name of the parameter and the value.
To exit the menu, briey press the button
(MENU)
PARAMETERS DESCRIPTION DEFAULT MIN MAX UNIT
1
AUTO CLOSE
Automatic re-closing time (0 = o󰀨) 0 0 900 s
2
PHOTO CLOSE
Re-closing time after the transit on PH1 (0 = o󰀨) 0 0 30 s
3
REACT TIME
Obstacle sensitivity
0 = maximum impact force
10 = minimum impact force
3 0 10
4
OPEN SPEED
Door speed in opening
1 = minimum speed
5 = maximum speed
4 1 5
5
SL-OP SPEED
Door speed during the slowing down phase in opening
1 = minimum speed
5 = maximum speed
1 1 5
6
CLOSE SPEED
Door speed in closing
1 = minimum speed
5 = maximum speed
4 1 5
7
SL-CL SPEED
Door speed during the slowing down phase in closing
1 = minimum speed
5 = maximum speed
1 1 5
5.1 - Basic parameters