Key Automation CT20324 - 4.5.2 - Deleting Memorised Buttons; 4.5.3 - Deleting Entire Receiver Memory; 4.5.4 - Memorising New Remote with Existing Remote

EN
13
5. A long ash (approximately three seconds) of the KEY LED conrms correct storage.
WARNING !
If the KEY LED emits a series of short ashes, the radio remote control button you
are trying to memorise is already present in the memory.
NOTE:after having memorise the radio remote control button, within seven seconds, it is possible to
associate another button of the same radio remote control or any button of another radio remote control,
to the same function, repeating the operations from point 3.
>3s
4.5.2 - Deletion of a memorised button of a radio remote control
Exit any menu, press and hold the button (DOWN-RADIO) until the display
Shows alternatively,
RADIO MENU .
►
MENU RADIO
1. Press and hold the button (DOWN-RADIO) until the KEY LED lights up; release the button.
(3s)
2. Within seven seconds, press and hold the button of the radio remote control to be deleted from the
receiver's memory until the KEY LED starts ashing; release the button.
►
3. Conrm deletion of the radio remote control by pressing the button (DOWN-RADIO)
4. A long ash of the KEY LED indicates that the radio remote control has been deleted.
3s
5. The control unit exits the RADIO MENU after seven seconds of inactivity or by briey pressing the button
(MENU)
If the transmitter you wish to delete was originally memorized using the LEARN ALL output (see paragraph 4.5.1, phase 2), the dele-
tion procedure mentioned above will delete all the functions associated with the buttons of that transmitter.
4.5.3 - Deletion of the entire receiver memory
Exit any menu, press and hold the (DOWN-RADIO) button until the display alternately shows RADIO
MENU .
►
MENU RADIO
1. Press and hold down the (DOWN-RADIO) button until the KEY LED lights up (approximately three
seconds); keep the button
(DOWN-RADIO) pressed until the KEY LED turns o󰀨; release the button.
►
►
►
2. After releasing the button the KEY LED starts to ash slowly; count the ashes.
3. At the third ash, briey press the button (DOWN-RADIO).
4. A long ash of the KEY LED indicates that all the radio remote controls have been deleted.
+3s
5. The control unit exits the RADIO MENU after seven seconds of inactivity or by briey pressing the button
(MENU)
4.5.4 - Memorisation of a button of a new radio remote control using a radio remote control already
saved in memory
It is possible to add the button of a new radio remote control to a control unit in which at least one
radio remote control has already been memorised
1. Near the control unit, press and hold the button of the new radio remote control to be added to the control
unit for at least ve seconds
(5s)
2. Near the control unit, press and hold down for at least three seconds the button of the already mem-
orised radio remote control to which the function to be duplicated on the new radio remote control is
associated.
NOTE: if step 1. has been correctly performed, the automation does not perform any manoeuvre and
it is possible to proceed with memorisation.
(3s)
3. Near the control unit, press and hold the same button on the new radio remote control used in point
1 for at least three seconds.
(3s)
4. Near the control unit, press and hold the same button on the old radio remote control used in point 2
for at least three seconds.
NOTE: the procedure has been correctly performed if the automation executes the command just
memorised.
(3s)
If the procedure is not completed, after a few seconds the control panel receiver returns to normal
operation.