Keychron K10 - Connection Modes Explained; Wired Connection Setup; Bluetooth Pairing and Connection

11
BLUETOOTH MODE
1. Switch the keyboard to Bluetooth option.
2. Backlit will be turned on.
3. Hold "Fn+1" key for 4 seconds to activate Bluetooth pairing (the Bluetooth indicator fast flashes
for 3 minutes to detect pairing.
4. Search for the Bluetooth device "Keychron K10" on your device and connect it (the Bluetooth
indicator goes off after successful pairing).
Note: This keyboard supports pairing up to 3 devices simultaneously via combination key
“fn” + “1” / “fn” + “2” / “fn” + “3”.
*The Bluetooth indicator will continue to flash for 3 minutes.
**Slow or failed connections may exist due to different Bluetooth versions, please make sure all the
settings are correct.
Backlit will be turned on.
BLUETOOTH/WIRED MODE (TOGGLE SWITCH)
WIRED MODE
I.Switch the toggle switch to Cable option (it only works when a USB cable is plugged in).
2.Connect our cable with your PC and keyboard.
3.Backlit will be turned on.
*Under Wired Mode, keyboard will not enter into Battery Saver Mode.
BLUETOOTH MODE
I. Switch the keyboard to Bluetooth option.
2. Backlit will be turned on.
3. Hold "Fn+l" key for 4 seconds to activate Bluetooth pairing (the Bluetooth indicator fast flashes
for 3 minutes to detect pairing.
4. Search for the Bluetooth device "Keychron KIO" on your device and connect it (the Bluetooth
indicator goes off after successful pairing).
Note: This keyboard supports pairing up to 3 devicessimultaneously via combination key
*The Bluetooth indicator will continue to flash for 3 minutes.
**Slow or failed connections may exist due to different Bluetooth versions,please make sure all the
settings are correct.
11