Keychron K11 Pro - Bluetooth and Wired Mode; Mode Toggle Switch; Switch Bluetooth Devices

18
SWITCH BLUETOOTH DEVICES
1. Switch the toggle switch to the Cable opon (it only works when a USB cable is plugged in).
2. Connect our cable with your PC and keyboard.
3. Backlighng will be turned on.
*Under Wired Mode, keyboard will not enter into Baery Saver Mode.
BLUETOOTH / WIRED MODE (MODE TOGGLE SWITCH)
1. Switch the toggle switch to the Bluetooth opon.
2. Backlighng will be turned on.
3. Hold “fn1+Q” key for 4 seconds to acvate Bluetooth pairing (the Bluetooth indicator fast
flashes for 3 minutes to detect pairing).
4. Search for the Bluetooth device “Keychron K11 Pro” on your device and connect it (the Bluetooth
indicator goes off aer successful pairing).
Note: This keyboard supports pairing up to 3 devices simultaneously via key combinaon “fn1” + “Q” /
“fn1” + “W” / “fn1” + “E”.
*The Bluetooth indicator will connue to flash for 3 minutes.
**Slow or failed connecons may exist due to different Bluetooth versions, please make sure all the
sengs are correct.
Short press key combinaon “fn1” + “Q” / “fn1” + “W” / “fn1” + “E” to switch to other device.
WIRED MODE
BLUETOOTH MODE