No-load current: 200 ± 20mA (DC 4.8V) 220 ± 20mA (DC 6V)
Stopping torque: 1.3 ± 0.01kg · cm (DC 4.8V) 1.5 ± 0.1kg · cm (DC
6V)
Stop current: ≦ 850mA (DC 4.8V) ≦ 1000mA (DC 6V)
Standby current: 3 ± 1mA (DC 4.8V) 4 ± 1mA (DC 6V)
(4)Experimental Preparation：
Insert micro:bit board into slot of keyestudio 4WD Mecanum Robot Car
Place batteries into battery holder
Dial power switch to ON end
Connect micro:bit to computer by USB cable
Open online Makecode editor
Import Hex profile (How to import?) , or click“New Project”and drag
blocks step by step(add MecanumRobot extension library first)
(How to add Mecanum_Robot extension?)
(5)Test Code:
Code path:
To Next Page
Loading...
