Keyestudio 4WD - Page 325

325
www.keyestudio.com
Hex file
KS4031(4032) folder/Makecode
Tutorial/Makecode Code/Project
19.1：Decode IR Remote
Control.hex
Project 19.1：Decode IR
Remote Control.hex
Click“Advanced”→“Serial”→“serial redirect to USB”
Place it into“on start”block.
Enter“IrRemote”→“connect IR receiver at P0”
Put it into“on start”block
IR receiving module is controlled by P9 of micro:bit board, so click P0 to
select P9.
Go to“Variables”→“Make a Variable...”→ “New variable name：” dialog
box，
Enter“val”and click“OK”to create variable“val”