Keysight E36200 Series Service Guide 5
– DO NOT OPERATE DAMAGED OR DEFECTIVE INSTRUMENTS
Instruments that appear damaged or defective should be made
inoperative and secured against unintended operation until they can be
repaired by qualified service personnel.
– DO NOT SUBSTITUTE PARTS OR MODIFY INSTRUMENT
Because of the danger of introducing additional hazards, do not install
substitute parts or perform any unauthorized modification to the
instrument. Return the instrument to a Keysight Technologies Sales and
Service Office for service and repair to ensure that safety features are
maintained. To contact Keysight for sales and technical support, refer to
the support links on the following Keysight website: www.keysight.com/
find/assist (worldwide contact information for repair and service).
– USE THE POWER CORD PROVIDED
Use the device with the power cord provided with the shipment.
– USE THE DEVICE AS SPECIFIED
If the device is used in a manner not specified by manufacturer, the
device protection may be impaired.
– DO NOT BLOCK VENTILATION HOLES
Do not block any of the ventilation holes of the device.
– OBSERVE ALL DEVICE MARKINGS BEFORE CONNECTING TO DEVICE
Observe all markings on the device before connecting any wiring to the
device.
– TURN DEVICE OFF BEFORE CONNECTING TO OUTPUT TERMINALS
Turn off the device power before connecting to the output terminals.
– ENSURE COVER IS SECURED IN PLACE
Do not operate the device with the cover removed or loosened.
To Next Page
Loading...
Need help?
General
