Keysight Technologies E4360A - Page 22

2 Performance Verification
22 Series E4360 Service Guide
Test Record Form – Keysight E4361A-J02
Keysight Model E4361A-J02 Report No _______________ Date __________________
Description Minimum Specs. Results Maximum Specs.
Constant Voltage Tests
Voltage Programming & Readback
Min. Voltage Vout
Voltage measured over interface
High Voltage Vout
Voltage measured over interface
− 29 mV
Vout − 29 mV
69.1191 V
Vout − 84.3 mV
__________
__________
__________
__________
+ 29 mV
Vout + 29 mV
69.2809 V
Vout + 84.3 mV
CV Load Effect
− 2 mV
__________ + 2 mV
CV Source Effect
− 2 mV
__________ + 2 mV
CV Ripple and Noise (at full and no load)
peak-to-peak (Fixed mode)
rms (Fixed mode)
peak-to-peak (SAS & Table mode)
rms (SAS & Table mode)
N/A
N/A
N/A
N/A
__________
__________
__________
__________
+ 150 mV
+ 25 mV
+ 136 mV
+ 21 mV
Constant Current Tests
Current Programming & Readback
Min. Current Iout
Current measured over interface
High Current Iout
Current measured over interface
−Current measured over interface
− 19 mA
Iout − 19 mA
7.965 A
Iout − 35 mA
Iout − 48 mA
__________
__________
__________
__________
__________
+ 19 mA
Iout +19 mA
8.035 A
Iout + 35 mA
Iout + 48 mA
CC Load Effect
− 1 mA
__________ + 1 mA
CC Source Effect
− 1 mA
__________ + 1 mA
Test Description E4361A-J02 Setting
Voltage Programming & Readback, Min 0 mV, 8.16 A
Voltage Programming & Readback, High 69.2 V, 8.16 A
CV Load Effect, Source Effect, Ripple and Noise 69.2 V, 8.16 A; Rload for ripple & noise= 8.65Ω
Current Programming & Readback, Min 0 mA, 71 V
Current Programming & Readback, High 8 A, 71 V
CC Load Effect, Source Effect 8 A, 71 V
SAS Curve settings for Ripple and Noise tests Isc = 8; Imp = 8; Vmp = 69.2; Voc = 75