Keysight Technologies E4360A - Page 29

Performance Verification 2
Series E4360 Service Guide 29
Test Record Form – Keysight E4362A-J04 and E4362A-J58
Report No _______________ Date __________________
Keysight Model
E4362A-J04 & E4362A
-J58 Description
Minimum Specs. Results Maximum Specs.
Constant Voltage Tests
Voltage Programming & Readback
Min. Voltage Vout
Voltage measured over interface
High Voltage Vout
Voltage measured over interface
− 66 mV
Vout − 66 mV
156.81625 V
Vout − 191.6 mV
__________
__________
__________
__________
+ 66 mV
Vout + 66 mV
157.18375 V
Vout + 191.6 mV
CV Load Effect
− 2 mV
__________ + 2 mV
CV Source Effect
− 2 mV
__________ + 2 mV
CV Ripple and Noise (at full and no load)
peak-to-peak (Fixed mode)
rms (Fixed mode)
peak-to-peak (SAS & Table mode)
rms (SAS & Table mode)
N/A
N/A
N/A
N/A
__________
__________
__________
__________
+ 150 mV
+ 34 mV
+ 239 mV
+ 27 mV
Constant Current Tests
Current Programming & Readback
Min. Current Iout
Current measured over interface
High Current Iout
Current measured over interface
−Current measured over interface
− 8 mA
Iout − 8 mA
3.7844 A
Iout − 15.6 mA
Iout − 21 mA
__________
__________
__________
__________
__________
+ 8 mA
Iout + 8 mA
3.8156 A
Iout + 15.6 mA
Iout + 21 mA
CC Load Effect
− 1 mA
__________ + 1 mA
CC Source Effect
− 1 mA
__________ + 1 mA
Test Description
E4362A-J04 and
E4362A-J58 Setting
Voltage Programming & Readback, Min 0 mV, 3.876 A
Voltage Programming & Readback, High 157 V, 3.876 A
CV Load Effect, Source Effect, Ripple and Noise 157 V, 3.876 A; Rload for ripple & noise = 41.3 Ω
Current Programming & Readback, Min 0 mA, 160.9 V
Current Programming & Readback, High 3.8 A, 160.9 V
CC Load Effect, Source Effect 3.8 A, 160.9 V
SAS Curve settings for Ripple and Noise tests Isc = 3.8; Imp = 3.8; Vmp = 157; Voc = 170