Keysight Technologies E5055A SSA-X

Installation Guide
Keysight E5055A
SSA-X Signal Source Analyzer

Keysight Technologies E5055A SSA-X Specifications

General

Resolution Bandwidth	1 Hz to 10 MHz
Input Impedance	50 Ω
Display	12.1-inch LCD
DANL (Displayed Average Noise Level)	-165 dBm/Hz
Input Connector	N-type (female)
Power Requirements	100 V to 240 V, 50 Hz to 60 Hz
Phase Noise	-136 dBc/Hz at 1 GHz carrier and 10 kHz offset

Summary

Notices

Safety Notices Definitions

Explains the meaning of CAUTION, WARNING, and NOTE notices.

Safety Summary

Unusual Operating Conditions

Safety Notice Supplement

General Safety Precautions

Grounding and Hazardous Environments

Emphasizes instrument grounding and warns against operation in explosive atmospheres.

Live Circuits and Service Safety

Advises caution around live circuits and restrictions on solo servicing and modifications.

1. Installation

Checking the Shipment

Outlines the procedure for verifying received items and checking for damage.

Environmental Requirements

Operating Environments

Ventilation Requirements

Protection Against Electrostatic Discharge (ESD)

Setting up a Static-Safe Workstation

Ensuring Adequate Free Space for Emergency Power Disconnection

Power Supply

Verification of the Power Supply

Confirms the voltage, frequency, and power consumption requirements.

Verification and Connection of Power Cable

Details steps for checking and connecting the power cable safely.

Blown Fuses

Fuse Types and Warnings

Starting the E5055 A

Turning the Power ON and OFF

Explains how to use the standby switch to power the instrument on and off.

Disconnection from Supply Source

Emergency Power Cutoff

Describes how to cut off power supply in emergencies by unplugging the power cable.

Initial Registration of E5055 A

Windows OS Registration

2. Troubleshooting

Troubleshooting during Startup

System Recovery

Notes on Executing Factory Recovery

Procedure to execute the factory recovery

Returning C Drive to Factory State