13
Keysight E5055A SSA-X Signal Source Analyzer
Installation Guide
1 Installation
This chapter provides information about how to set up the Keysight E5055A.
Checking the Shipment
After you receive the analyzer, carry out checks during unpacking according to
the following procedure.
Step 1. Check that the packing box or shock-absorbing material used to package the
analyzer has not been damaged.
Step 2. Check the packaged items supplied with the analyzer for any damage or
defects.
Step 3. By referring to the furnished contents list, check that all packaged items
supplied with the analyzer have been received as per the specified options.
Step 4. After checking, if one of the following applies, contact your nearest Keysight
Technologies sales and service office.
1. The packing box or shock-absorbing material used to package the analyzer
has been damaged or the shock-absorbing material has traces where
extreme force has been applied.
2. A packaged item supplied with the analyzer has mechanical damage or
defects.
When unpacking the analyzer, if the exterior of the analyzer (such as the
cover, front/rear panel, LCD screen, power switch, and port connectors)
appear to be damaged during transport, do not turn on the power switch.
Otherwise, you may get an electric shock.
If the packing box or shock-absorbing material has been damaged, leave
the packing box and shock-absorbing material as is until other inspection
items are checked as follows.
To Next Page
Loading...
Need help?
General
