Keysight E5055A SSA-X Signal Source Analyzer 19
Installation
Starting the E5055A
Figure 1-2 Power cable receptacle
Disconnection from Supply Source
The power supply of the E5055A is cut off by disconnecting the plug of the
power cable (on either AC outlet side or E5055A side). When it is necessary to
disconnect the power supply in order to avoid shock hazards, etc., pull out the
power cable plug from either the AC outlet side or the E5055A side.
To allow this operation to be performed smoothly, be sure to follow the
guidelines in “Ensuring Adequate Free Space around Analyzer for
Immediate Disconnection of Power Cable in Case of Emergency” on
page 15.
When turning the power OFF under normal circumstances, always follow
the methods described in “Turning the Power OFF” on page 18.
To Next Page
Loading...
Need help?
General
