Keysight Technologies EPM Series User Manual

2 Performance Tests
56 Keysight E4416A/E4417A Power Meters Service Guide
10 Switch to the power sensor's upper range:
– Press .
– Move to the Range parameter using the up/down arrow keys.
– Scroll through the Range values by pressing . Select a value of
UPPER.
– Press .
11 Verify that the display reads −30 dBm ± 1 dB. Record the reading in Table 2-6.
12 Turn on the power reference:
Press
,
13 Switch to the power sensor's lower range:
– Press .
– Move to the Range parameter using the up/down arrow keys.
– Scroll through the Range values by pressing . Select a value of
LOWER.
– Press .
14 Disconnect the 30 dB attenuator and reconnect the test setup as shown in
Figure 2-7.
15 Turn on the power reference:
Press
,
16 Verify that an overload error is displayed on the status line at the top of the
power meter's display and that the display reads 999.99 dBm.
Channel
Change
Done
Zero
Cal
Power Ref Off
Channel
Change
Done
Zero
Cal
Power Ref On

Keysight Technologies EPM Series Specifications

General

Brand	Keysight Technologies
Model	EPM Series
Category	Measuring Instruments
Language	English