662 Keysight N9927-90001 User’s Guide
System Settings
System Configuration
—Press System 7.
—Then System Configuration
.
—Then More
—Then Firmware Update
—Then Start Installer
— The Installer software opens after a couple of seconds.
— Then the arrows or the knob to scroll to the firmware you want to
install.
—Press Start Install
—“Current Step Progress:” bar and a “Total Progress:” bar are
displayed along with this message: “Copying package. Do not
remove install media.”
— When the installation is completed, the FieldFox reboots.
How to backup files
This procedure backs up your user data to a USB or SD card. See also “How to
restore files” on page 662.
From the initial Installer menu:
—Press Utility
—Then Backup Data
— A message is displayed: “Choose backup file location.”
— Then choose either SD Card
or USB
— A progress bar and a message is displayed: “Saving user data…”
—Press Cancel
to exit without backing up your files and returning to the initial
Installer menu.
How to restore files
This procedure restores user files from a USB or SD card. See also “How to backup
If no files are displayed, verify that a USB memory or SD Card is installed
and press Refresh List
.
If you backup multiple versions of the user files, the FieldFox appends a
“_#” to each subsequently stored file. During restore, the file with the
highest appended number is loaded into the FieldFox.
To Next Page
Loading...
Need help?
General
