Keysight M937xA PXIe Service Guide 2-3
Tests, Adjustments, and Troubleshooting
Before You Begin
Before You Begin
Before checking, verifying, or adjusting the analyzer, refer to the following
paragraphs to:
- get the required Service Test equipment
- make sure the operating environment is within its requirements
- make sure that proper electrostatic discharge (ESD) protection is provided
- make sure the analyzer has warmed up properly to achieve system stability
- review the principles of connector care
Get the Required Service Test Equipment
The test equipment in this list covers the full 26.5 GHz range of the
M9375A module. For lower frequency modules, the list can be modified to
use the appropriate lower frequency equipment. For example, with a
M9370A 4 GHz module, a valid substitution for the N8485A power sensor
is the N8482A (specified to only 6 GHz).
Equipment required for System Verification is listed in Table 2-1,
“Equipment Used in the System Verification Procedure”, on page 2-23
To Next Page
Loading...
Need help?
General
