Keysight M937xA PXIe Service Guide 2-5
Tests, Adjustments, and Troubleshooting
Before You Begin
Get the Hardware Required for your GPIB Instruments
The hardware required to connect your GPIB instruments to the network
analyzer depends on the type of controller you use.
- If using an embedded controller, you need an M9036-31301 GPIB Micro 2
cable.
-If using a remote controller, you need a GPIB card for the PC.
Verify the Operating Environment
For Operating Environment information, refer to the online Data Sheet at
http://literature.cdn.keysight.com/litweb/pdf/M9370-90002.pdf.
Protect Against Electrostatic Discharge (ESD)
For information on protecting against electrostatic discharge (ESD), refer
to the online Startup Guide at
http://literature.cdn.keysight.com/litweb/pdf/M9370-90001.pdf
Adapters
3.5 mm (-m- to -m-)
Return Loss:
³32 dB
83059A
85052-60014
d
P, A
3.5 mm (-f- to -f-)
Return Loss:
³32 dB
83059B
85052-60012
d
P
2.4 mm (-m-) to 3.5 mm
(-m-), (Qty 2)
Return Loss:
³24 dB
11901A Any equivalent P
Attenuators
3.5 mm (-m- to -f-),
10 dB fixed attenuator, (Qty
2)
Accuracy: ±0.5 dB
Freq: DC to 26.5 GHz
8493C
Option 010
Any equivalent P
Tools
5/16 inch (8 mm), open-end
torque wrench
1.13 N.m (10 in-lb) setting (for
semi-rigid cables and 50 ohm
loads)
N/A N/A P, A
Cable removal tool N/A
5002-3361
e
N/A P, A
a. P = Performance tests, A = Adjustments
b. Refer to “Get the Hardware Required for your GPIB Instruments” on page 2-5.
c. Required only if using an embedded controller. Refer to “Get the Hardware Required for your GPIB Instruments” on
page 2-5.
d. Included in the 85052B/D calibration kits.
e. Included with the M937xA shipment.
Equipment Critical Specifications Recommended
Model or Part
Number
Alternate Model
Number
Use
a
To Next Page
Loading...
Need help?
General
