Keysight E8257D - Page 28

22 Keysight E8257D/67D & E8663D PSG Signal Generators Installation Guide
Operation Verification
Checking the Output Power
Perform the following procedure to check the signal generator output power:
1. Zero and calibrate the power sensor to the power meter as shown:
Table 3-6 Recommended Equipment for the E8663D
E8663D
Option
503
E8663D
Option
509
Test
Equipment
Recommended Keysight
Test Equipment
✔✔
Power Meter Keysight E4418B E- Series
power meter
or Keysight E4419A/B
E- Series power meter
✔✔
Power
Sensor,
Input:
Type- N (m)
Keysight E9304A E- Series
power sensor
or Keysight 8482A power
sensor
✔✔
Power
Sensor,
Input: APC
3.5 (m)
Keysight E4413A E- Series
power sensor
✔✔
Power
Sensor,
Input: 2.4
mm (m)
Keysight 8487A Option
H84 power sensor (Option
H84 adds a Standards Lab
Calibration)
✔✔
Adapter,
3.5 (f) to (f)
Keysight 1250- 1749 APC
3.5 (f) to
(f) adapter
✔✔
Adapter,
3.5 (f) to
Type- N (m)
Keysight 1250- 1744
APC 3.5 (f) to Type- N (m)
adapter