Keysight X-Series Signal Generators Error Messages 39
Error Messages
List of Error Messages
Invalid file or device name.
-252 Missing media; The media for file {name} is missing. This error
typically occurs if 'File>Internal/USB Storage Selection' is set to
Ext and there is no USB media detected. To fix this change the setting
to Auto or Internal.
The media for file {name} is missing. This error typically occurs if
'File>Internal/USB Storage Selection' is set to Ext and there is no
USB media detected. To fix this change the setting to Auto or
Internal.
-252 Missing media; No SSD found. A backup RAM disk will be used for
storage instead.
No SSD was found at boot. A backup RAM disk will be used for
storage instead.
-250 Mass storage error; Unexpected memory media found and ignored:
{name}.
{name} will be used for storage instead.
Memory media that is not configured to be used was found. The
memory media will be ignored.
-241 Hardware missing; Cannot access a baseband generator that does not
exist.
Tried to retrieve access information that was not created for a
given baseband generator. The hardware probably does not exist.
-241 Hardware missing; The firmware has booted in no-hardware mode.
To Next Page
Loading...
