44 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
This error occurs when trying to open a header file, the file does
not match any known header format or does not exist. {name} is the
filename being accessed.
-230 Data corrupt or stale; The user file version is not recognized. {name}
An error has occurred while loading a user file where the version
of the file is not recognized as a supported version.
-230 Data corrupt or stale; {name}
The sequence file that you are attempting to run is the wrong size.
-224 Illegal parameter value
Used where an exact value was expected from a list of
possibilities.
-224 Illegal parameter value; Analog bus node not present
The analog bus node that was selected is not a valid node in the
system.
-224 Illegal parameter value; Board name not present
The board name that was selected is not a valid board in the
system.
-224 Illegal parameter value; Command requires at least one data value.
A modulation type cannot be created without data.
To Next Page
Loading...
