Keysight X-Series Signal Generators Error Messages 151
Error Messages
List of Error Messages
*** No documentation ***
800 Digital module configuration error; Could not configure FPGA(s) on the
Digital module: {name}. Report this error to service office.
This error is reported when the FPGAs on the digital module FPGAs
failed to be configured. The digital module will not work properly
in this state.
801 Digital module VCO unlock error; The VCO on the digital module is
unlocked. Check to make sure the clock settings are correct and the
correct clock reference is connected.
The VCO on the digital module is unlocked. Check to make sure the
clock settings are correct and the correct clock reference is
connected.
802 Digital module overrange error; The output data is being clipped by the
resampler. Reduce the scaling under the data menu to correct this
problem.
This error is reported when the output of the resampler is being
clipped.
803 Digital module input FIFO overflow error; There are more samples being
produced than can be consumed at the current clock rate. Verify that
the digital module clock is set up properly.
This error is reported when the digital module clock setup is not
synchronized with the rate the samples are entering the digital
module. Verify that the input clock rate matches the specified
clock rate under the clock setup menu.
To Next Page
Loading...
