Keysight X-Series Signal Generators Error Messages 57
Error Messages
List of Error Messages
requires the external reference narrow BW setting.
When setting the external reference frequency to anything other
than 10MHz the external reference bandwidth must be set in the low
or narrow setting. This error is displayed when the the external
reference frequency causes the external reference bandwidth to be
changed from wide to narrow.
-221 Settings conflict; The application could not be turned on or have its
settings changed because the current baseband operating mode does not
support it. See the AUX Function menu.
The application could not be turned on or have its settings changed
because the current baseband operating mode does not support it.
The baseband operating mode setting is found under the AUX Function
menu.
-221 Settings conflict; ARB marker RF blanking cannot be on with pulse
modulation.
There is a hardware conflict between pulse modulation and ARB
marker to RF blanking. ARB marker to RF blanking will be turned
off.
-221 Settings conflict; At least one of the channels must be on in order to
turn the mode on. WCDMA has been turned off.
To output a valid RF signal, at least one channel must be turned
on. Since all channels are off, WCDMA mode has been turned off to
avoid undefined behavior.
-221 Settings conflict; At least one of the channels must be on in order to
To Next Page
Loading...
