58 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
turn the mode on. {name} has been turned off.
CDMA2000 or 1xEV-DV requires at least one channel to be on to turn
the mode on. Having at least one channel on in the current link
direction, and in the case of reverse link the current Operating
Mode, allows the mode to be turned on.
-221 Settings conflict; Atten Hold is not compatible with Optimize
Harmonics mode. Optimize Harmonics has been turned off.
The Optimize Harmonics mode adjusts the attenuator; therefore, it
is not compatible with Attenuator Hold mode .
-221 Settings conflict; The Atten Hold is not compatible with Optimize
Signal/Noise mode. Optimize S/N has been turned off.
The Optimize Signal/Noise adjusts the attenuator; therefore, Atten
Hold ON and Optimize Signal/Noise ON are not compatible.
-221 Settings conflict; auto power search was aborted due to invalid
setting. Check the {name} parameters, then press APPLY to rerun auto
power search.
Auto power search is aborted for the reason described in error
message. Check the setting, then press APPLY to run Auto power
search.
-221 Settings conflict; BBG data clock has been set to internal. Ext data
bit clock does not work with combined GSM/EDGE.
Combined GSM/EDGE does not work with an external bit clock.
However it can be used with an external symbol clock.
To Next Page
Loading...
