64 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
Compressed Mode should be off when
any antenna is selected as Transmit Diversity
or OutOfSyncTest is on
or Transport Position is Flexible.
-221 Settings conflict; conflict between code = {value}, spread factor =
{value} and code = {value}, spread factor = {value}
A channelization code conflict exists between two codes, each at
its respective spread factor. Parameters 1 and 3 are channelization
codes. Parameters 2 and 4 are spread factors.
-221 Settings conflict; conflict between code = {value},data rate = {value}
sps and code = {value}, data rate = {value} sps
A channelization code conflict exists between two codes, each at
its respective data rate. Parameters 1 and 3 are channelization
codes. Parameters 2 and 4 are data rates.
-221 Settings conflict; Could not perform File Header operation while
format is off: {name}.
This error is reported when a file header command is tried when the
format is not on. File Headers can only be modified while the
format the file is associated with is turned on. {name} is a string
describing the Format.
-221 Settings conflict; The current data rate is not valid for this radio
configuration. Data rate changed to the default rate.
The new radio configuration does not support the current data rate.
To Next Page
Loading...
