Keysight X-Series Signal Generators Error Messages 67
Error Messages
List of Error Messages
-221 Settings conflict; The Digital Data state was forced off because the
connection to the digital module was lost. You must reconnect the
module to turn Digital Data back on.
When the digital module is disconnected while the state is on, the
state will be forced off. This error is reported to notify the user
that the state was forced off.
-221 Settings conflict; The Digital Data state was forced off because the
current format is not supported with the digital module.
The digital module has to be turned off as the current format is
not supported with it.
-221 Settings conflict; The Digital Data state was forced off because there
are no longer anyformats turned on.
All formats were turned off, so the digital module has to be turned
off as well.
-221 Settings conflict; Doppler shift has been reduced to reflect the new
frequency.
The requested frequency is incompatible with the current value of
the Doppler shift. The Doppler shift has been set to the maximum
value compatible with the new frequency.
-221 Settings conflict; Enabled modulation source conflicts with previously
enabled modulation source. Previous modulation disabled.
Three sources are shared by FM1/PM1, AM1/AM2, FM2/PM2, pulse and
burst envelope: INT, EXT1, and EXT2. Each source can be used by
To Next Page
Loading...
