78 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
If all slaves in the Multi-BBG Sync configuration are MXG-As, then
the number of MXG-A slaves has been lowered by 1 in order for this
slave to be accommodated as an MXG-B.
-221 Settings conflict; Multi-BBG Sync: Turn off the Modulation Modes in
all instruments before attempting sync.
The BBG Modulation Mode (Dual Arb, Multitone, etc) must be off
before attempting to sync the instruments configured for Multi-BBG
Synchronization.
-221 Settings conflict; New hardware settings can no longer support the
last IQ Out selection. IQ Out defaulted to Source 1.
Based on new settings in the vector modulation system, a previous
setting related to the IQ Output (rear panel) is no longer valid.
The setting will be default to the input selected for Source 1.
-221 Settings conflict; New wave shape changes limit for internal
frequency: frequency changed to new limit.
When using the internal modulation source, the upper limit varies
for the different waveforms. If the user changes the waveform when
the internal source frequency is higher than that allowed for the
new waveform, the frequency for the source will be changed, and the
user informed of that change with this message.
-221 Settings conflict; Nfirst1 - Nlast1 <= 6
GAP1 is a single frame method gap that is greater than 7 slots
long. DTX slots per frame should be less than 8.
To Next Page
Loading...
