Keysight X-Series Signal Generators Error Messages 81
Error Messages
List of Error Messages
S/N has been turned off.
The analog modulation and Optimize S/N cannot be used at the same
time. This error is reported when the user attempts to activate
analog modulation while Optimzie S/N activated. The analog
modulation mode that was requested will be turned on and Optimize
S/N will be turned off.
-221 Settings conflict; Option 403 is required to be able to turn Noise on.
Option 403 (AWGN) is required to enable the AWGN portion of option
401 (Realtime cdma2000) or option 414 (Realtime 1xEV-DV).
-221 Settings conflict; OutOfSyncTest should be off when any antenna is
selected as Transmit Diversity or Compressed Mode is on.
Compressed Mode should be off when any antenna is selected as
Transmit Diversity or OutOfSyncTest is on.
-221 Settings conflict; Output impairments are not allowed when DSIM output
(option 003) is in operation.
Output impairments are not allowed when DSIM output (option 003) is
in operation. The following SCPI commands will be set as described
below and the user will not be able to alter them while DSIM output
is on.
[:SOURce]:DM:EXTernal:OUTPut:POLarity NORMal
[:SOURce]:DM:IQADjustment[:STATe] OFF
[:SOURce]:DM:INTernal:EQUalization:FILTer:STATe OFF
[:SOURce]:DM:INTernal:CHANnel:OPTimization EVM
[:SOURce]:DM:INTernal:CHANnel:CORREction[:STATe] OFF
To Next Page
Loading...
