82 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
-221 Settings conflict; The output rate of the baseband has limited {name}.
When the Digital Module is operating in a setup that requires the
baseband to output at a rate different from the output DAC, then
some parameters (specified with the first {name}) must be limited.
-221 Settings conflict; Pattern repeat is changed to continuous because
data source is external.
Single is not a valid repeat setting for an external data source.
-221 Settings conflict; Power Meter Servo cannot be used with marker
amplitude. Marker amplitude has been turned off.
Power Meter Servo cannot be used with marker amplitude.
-221 Settings conflict; Power Meter Servo cannot be used with marker
amplitude. Power Meter Servo has been turned off.
Power Meter Servo cannot be used with marker amplitude.
-221 Settings conflict; Power Meter Servo cannot be used with pulse
modulation. Power Meter Servo has been turned off.
Power Meter Servo cannot be used with pulse modulation.
-221 Settings conflict; Power Meter Servo cannot be used with pulse
modulation. Pulse modulation has been turned off.
Power Meter Servo cannot be used with pulse modulation.
-221 Settings conflict; Power Meter Servo mode could not be enabled. Check
To Next Page
Loading...
